Products

Synchroniser Assembly for 3rd and 4th gear, mounted on the mainshaft of the R380 five-speed manual gearbox. The assembly locks the selected gear t...

Synchroniser Assembly for 5th gear, mounted on the mainshaft of the R380 five-speed manual gearbox. The sliding sleeve is moved by the fifth-gear ...

DIFFERENTIAL - ASSEMBLY - FRONT AXLE - 24 SPLINE - 4 BOLT FLANGE - D2

Clutch Slave Cylinder Push Rod within the Clutch Actuation Assembly, transmitting hydraulic force from the external slave cylinder to the clutch re...

Clutch Release Bearing installed within the Clutch & Flywheel Assembly, operating between the clutch release fork and the clutch cover diaphrag...

Clutch Slave Cylinder for the hydraulic clutch release system on Defender and Discovery 2 models fitted with the R380 manual gearbox. Mounted on t...

Differential Pinion Oil Seal with a double sealing lip, for the front and rear differentials. It is press-fitted into the differential housing aro...

Thrust Washer - mainshaft thrust washer for the R380 five-speed manual gearbox. Located at the mainshaft 5th/reverse gears, it controls end-float ...

Gearbox Mainshaft Oil Seal, fitted where the mainshaft passes through the gearbox casing on the 5-speed manual transmission. It runs against the r...

Axle Oil Level Plug - Plastic is the filler and level plug for the front and rear differential housings. This plug seals the oil level/filler aper...

Axle Oil Level Plug - a brass filler and level plug for the axle differential housing, sealed by an O-ring. It threads into the level/filler port ...

Flanged Locking Nut, M10. General-purpose threaded fastener. The integral flange spreads the clamp load over a wider bearing area, removing the ne...

Flange Nut - M12 - an M12 fastener with an integral flanged face, used throughout the suspension assembly. The wide flange spreads the clamping lo...

Nyloc Flanged Nut - M8 flanged nut with a nylon insert, used on front suspension fixings. The nylon collar deforms around the bolt thread as the n...

Viscous Fan Coupling Spanner Set, a pair of thin-section spanners (32 mm and 36 mm) for removing and refitting the viscous fan coupling at the wate...

Oil Filter Wrench - a removal tool for the spin-on oil filter on the Td5 2.5L diesel engine. The wrench locates over the end of the filter caniste...

Wheel Arch Kit - set of replacement wheel arch mouldings for the outer body panels. The mouldings cover the joint between the body panel and the w...

Centre Differential Lock Lever Kit - LT230 - linkage assembly that adds a manual centre differential lock control to the LT230 transfer case. The ...

Watts Linkage Centre Pivot for the rear axle, supplied with bushes. The centre pivot is the pivoting hub of the rear Watts linkage, which locates ...

Air-operated differential locker for a 24-spline differential, replacing the standard differential centre in the axle. When engaged, it locks both...

Locking Fuel Cap - locking cap for the fuel tank filler neck. Seals the filler neck and locks with a key to deter fuel theft and tampering.

Gear Change Kit - R380

Double Cardan Joint Kit for the Discovery 2 front propshaft. The Discovery 2 front propshaft uses a double cardan joint assembly incorporating thr...

Connector - 5-Way Switch - Black - a black five-way connector housing used in the vehicle wiring harness. The housing mates to a five-pin switch a...

Wheel Arch Kit is a set of 75 mm extended wheel arch extensions that give coverage for wider tyres and wheel spacers. The 75 mm profile clears tyr...

Spare Wheel Cover for an externally mounted spare wheel sized 7.50x16 (235/85R16). Constructed from soft vinyl, it shields the spare wheel and tyr...

Dash Repair Kit in grey - a set of pre-formed overlay panels that fit over the existing upper dashboard moulding. The panels cover the areas of th...

Cylinder Head Set for the Td5 2.5L 5-cylinder turbo diesel - the gaskets and seals disturbed when the cylinder head is removed and refitted. Suppl...

Cylinder Head Set for the Td5 2.5L 5-cylinder turbo diesel - the gaskets and seals disturbed when the cylinder head is removed and refitted, suppli...

Cylinder Head Set for the Td5 2.5L 5-cylinder turbo diesel - the gaskets and seals disturbed when the cylinder head is removed and refitted, togeth...

Bottom End Gasket Kit supplies the gaskets and seals needed to reseal the lower half of the Td5 engine - the cylinder block, crankshaft and sump as...

Towing Bracket Slider is the sliding tongue section of a Dixon Bate adjustable towing bracket, which sets and locks the hitch at the required heigh...

Tow Ball & Pin Hitch Assembly for the towing system, mounting to the rear towing bracket. The assembly combines a tow ball for standard ball-c...

Steering & Sump Guard - underbody skid plate. This guard fits beneath the front of the vehicle to shield the steering linkage and the engine s...

Flywheel Clutch Kit - TD5

Wheel Arch Trim Kit providing a full six-piece set of extended wheel arch flares that fit over the standard arches. The flares extend approximatel...

Braided Brake Hose Kit, extended by 150mm, covering the flexible sections of the hydraulic brake circuit between the chassis-mounted brake pipes an...

Brake Hose Kit is a set of four +40mm extended stainless-steel braided brake hoses, one for each wheel, replacing the flexible sections of the hydr...

Head Bolt Set - cylinder head fixings for the 2.5L Td5 five-cylinder turbo diesel engine. The bolts clamp the cylinder head to the block, compress...

Alloy Intake Pipe Kit for the induction system of the Td5 2.5L 5-cylinder turbo diesel, replacing the moulded intake ducting between the air flow m...

Polyurethane Boot - Defender - Discovery 1/2 - RRC - P38

Fuel Filter Non-Return Valve Kit for the Td5 fuel filter housing, in the low-pressure fuel supply circuit. The non-return valve maintains fuel pri...

Oil Pump Gear Set - replacement gear set for the crankshaft-driven oil pump in the Rover V8 petrol engine lubrication system. The gears run in the...

RR Spring Rear Heavy Duty - Discovery

Air Filter - panel air filter for the engine air intake, seated in the airbox upstream of the intake ducting to trap airborne dirt before it reache...

Intermediate Exhaust Pipe in stainless steel, forming the centre section of the Td5 exhaust system. This is a straight-through link pipe fitted in...