Products

Starter Motor for the engine starting system, mounted at the engine-to-transmission bellhousing. When cranking, the integral solenoid drives the p...

O-Ring for the variable valve timing (VVT) solenoid. Seals the VVT solenoid where it locates into the cylinder head, retaining oil pressure to the...

M16 Nut for the front suspension arm. Secures a front suspension arm mounting fastener, holding the joint under suspension loads.

Bolt for the suspension mountings. Secures front and rear suspension arms, struts and springs at their attachment points under suspension loads.

Nut is a fastener used to secure suspension and mounting components at their attachment points. It is specified at several chassis locations, incl...

CV Boot Kit for the front drive shaft constant velocity joint, providing the components required to renew the protective boot. The CV joint boot r...

Diverter Solenoid Valve is the turbocharger compressed-air recirculation (diverter) valve in the boost-control circuit. On throttle lift-off it re...

Anti-Roll Bar Link - Front connects the front anti-roll (stabiliser) bar to the suspension, forming part of the front anti-roll bar assembly. The ...

Accessory Drive Belt from the front-end accessory drive. The primary serpentine belt driven by the crankshaft pulley to turn the engine ancillarie...

Ignition Coil for V6 and V8 petrol engines, mounted directly on the spark plug in a coil-on-plug arrangement. The coil steps up the battery supply...

Crankshaft Timing Trigger Wheel for V6 and V8 diesel engines. The toothed reluctor wheel mounts on the crankshaft and passes the crankshaft positi...

Crankshaft Timing Trigger Wheel for V6 and V8 diesel engines. The toothed reluctor wheel mounts on the crankshaft and passes the crankshaft positi...

Mass Air Flow Sensor is part of the air intake system, mounted in the intake ducting downstream of the air filter. It measures the mass of air dra...

Lambda (Oxygen) Sensor, front position in the exhaust system, upstream of the catalytic converter. The sensor measures the oxygen content of the e...

Idler Pulley for the auxiliary drive belt, 70mm diameter, positioned within the front-end accessory drive system. The pulley guides and stabilises...

Transmission Oil Cooler - part of the automatic gearbox cooling circuit, fitted to ZF 8-speed automatic transmissions. The cooler dissipates heat ...

Crankshaft Rear Seal and Retainer - the rear main oil seal and its housing, part of the cylinder block and plugs assembly at the rear of the cranks...

Fuel Injector Refit Kit - the seals and retainer required when removing and refitting a fuel injector on 3.0L V6 and 5.0L V8 supercharged petrol en...

Fuel Injector Refit Kit - the seals and retainer required when removing and refitting a fuel injector on 3.0L V6 and 5.0L V8 supercharged petrol en...

Bolt is a threaded fastener used within the chassis and suspension assemblies. It secures mounting points across suspension, stabilizer bar and re...

EGR Outlet Gasket seals the outlet joint of the exhaust gas recirculation (EGR) assembly. Fitted to the 3.0L V6 diesel (TDV6) engine, it forms a g...

Suspension Arm Bolt secures a front suspension arm to its mounting on the chassis/subframe, part of the front suspension arm mounting hardware. Th...

Anti-Roll Bar Bush for the front conventional stabiliser bar. This rubber insulator clamps the front anti-roll bar to its chassis mounting bracket...

Torque Converter Screw for the automatic transmission drive coupling. This fixing secures the torque converter to the drive plate, transmitting en...

Brake Disc - front axle, vented, 360mm - operating in the hydraulic disc brake circuit at the front wheels. The internally vented construction cha...

Water Pump for the fuel-fired heater (FFH) circuit. This auxiliary electric pump circulates coolant through the fuel-fired pre-heater. It moves he...

Tailgate Switch operates within the powered tailgate and luggage compartment locking controls. The switch signals tailgate release, actuating the ...

Fuel Supply Manifold distributes fuel to the injectors on the left-hand cylinder bank of the 3.0L V6 diesel engine. It forms part of the engine's ...

Inlet Valve for the supercharged 3.0L V6 petrol engine (AJ126). The inlet valve seals against its seat in the cylinder head and opens on the intake...

Upper Inlet Manifold Gasket for the supercharged 3.0L V6 petrol engine. It seals the joint at the upper section of the two-piece inlet manifold, ma...

Upper Inlet Manifold Gasket for the supercharged 3.0L V6 petrol engine. It seals the joint at the upper section of the two-piece inlet manifold, ma...

Lower Inlet Manifold Gasket for the supercharged 3.0L V6 petrol engine. It seals the lower section of the inlet manifold to the cylinder head, seal...

Fuel Filter - the primary fuel filter in the low-pressure supply circuit of the 3.0L V6 diesel engine. Positioned between the fuel tank delivery l...

Crankshaft Seal - Rear - 1.5 mm seals the rear of the crankshaft where it exits the cylinder block at the flywheel and drive plate end. Supplied c...

Air Suspension Connector joins the valve block to a high-pressure air line within the air suspension pneumatic circuit. The fitting forms a sealed...

Transfer Box Drive Chain for the transfer case. It transmits drive from the transfer case input to the output, distributing torque to the front and...

Brake Pad Wear Sensor - Front The electronic brake pad wear sensor for the front axle, part of the braking system's pad-wear warning circuit. It lo...

Brake Caliper for the front left-hand position, supplied without brake pads. The caliper houses the hydraulic pistons that clamp the brake pads ag...

Brake Calliper for the front axle, right-hand side, part of the front disc brake assembly. The calliper houses the hydraulic pistons and clamps th...

Drain Plug Sealing Washer seals the M18 oil drain and filler plug on the transfer case. The washer deforms as the plug is tightened to form a leak...

Transfer Box Oil is the lubricant specified for the single-speed transfer case. It lubricates the transfer case internals and is used when carryin...

Coolant Hose carries engine coolant between the thermostat housing and the engine on the supercharged 3.0L V6 and 5.0L V8 petrol engines. It runs f...

Timing Chain Guide that locates and supports the timing chain along its run within the timing drive. It controls the chain path and reduces vibrat...

Bolt is a chassis fastener securing the front and rear crossmember and stabiliser (anti-roll) bar mountings. Supplied individually.

Front Brake Pad Set for the front axle. Supplied as an axle set of disc brake pads for the front calipers. The pads act against the front brake di...

Front Brake Pad Set for the front axle. Supplied as an axle set of disc brake pads for the front calipers. The pads use a ceramic friction compoun...

Brake Fluid - DOT 4 low-viscosity hydraulic brake fluid, supplied in a 1 litre container. It transmits pedal pressure through the hydraulic brakin...