Products

Exhaust Mounting Rubber (insulator/hanger) in the exhaust system suspension. Supports the exhaust system on its mounting brackets, isolating exhau...

Sealing Washer is the fuel injector sealing washer for the Ingenium diesel engine (2.0L and 3.0L AJ20 / AJ21 diesel). It seats at the base of the ...

Front Crankshaft Oil Seal located at the front of the cylinder block, on the crankshaft. Seals the crankshaft where it exits the front of the engi...

Oil Pan Gasket - seals the oil pan (sump) to the cylinder block on the 4.4L V8 diesel engine. It forms the oil-tight joint between the sump and th...

Wheel Centre Cap - set of four alloy wheel centre caps in Titan Silver. The centre cap clips into the hub bore of an alloy wheel, covering the hub...

Wheel Cover set, fitted over the road wheels. The covers clip over the wheels to give a finished appearance and shield the wheel face from road di...

Wheel Centre Cover fits into the central hub bore of an alloy wheel, concealing the hub and wheel-mounting hardware behind a finished cap that clip...

Wheel Cover for the road wheel. The cover fits over the wheel to give a finished appearance and shield the wheel face from road dirt and brake dus...

Timing Belt Tensioner

Nut used in exterior body panel and trim fixings. Secures body components such as the luggage compartment door finisher, radiator grille and bumpe...

Timing Chain Tensioner for the timing chain drive of the 5.0L V8 (AJ133) and 3.0L supercharged V6 petrol engines. It bears against the timing chain...

Lock Actuator for the tailgate / luggage compartment latch, part of the rear closure locking controls. This electric actuator drives the latch to l...

Air Suspension Compressor The pump that generates and supplies compressed air to the four-corner electronic air suspension system. Driven by an el...

Camshaft Sprocket A component of the timing gear that transmits drive from the timing chain to the camshaft, keeping valve operation synchronised w...

Vacuum Pump Gasket sealing the vacuum pump to the engine. Forms the joint between the vacuum pump and its mounting face, maintaining the seal for ...

Sealing Ring for the oil level sensor connection at the sump. Seals the oil level sensor wiring connector where it passes through the oil pan (sum...

Oil Pump for the 3.0L V6 diesel engine lubrication system. The pump draws oil from the sump and delivers it under pressure to the engine oil galle...

Oil Filter filters the engine oil on the 2.0L 16V turbocharged petrol engine. Part of the oil cooler and filter assembly, it removes contaminants ...

Oil Filter for the engine lubrication system. Filters contaminants from the engine oil, protecting the lubrication circuit. Fitted to the 2.0L 16V...

Flywheel Bolt - hex head fastener that secures the flywheel to the rear crankshaft flange within the engine driveline assembly. Fitted to the 3.0L...

Inlet Manifold distributes incoming charge air to the cylinder head inlet ports, forming part of the air intake system on the 3.0L V6 diesel engine...

Water Pump for the engine cooling circuit, fitted to supercharged petrol applications (3.0L DOHC GDI supercharged V6 and 5.0L AJ133 DOHC supercharg...

Hex Head Bolt - M14 x 148mm fastener used at the front crossmember and stabiliser bar, front suspension arm, rear bumper and tow bar mountings. A ...

Oil Pump for the engine lubrication system of the supercharged petrol V6 and V8 (AJ133) engines. Driven from the crankshaft, the oil pump draws oi...

Parking Camera for the surround camera system. The camera supplies a video feed to the vehicle's parking and surround-view display, assisting with...

Transmission Mount Insulator locating the transmission mounting bracket. The rubber-to-metal insulator supports the transmission against the body ...

Brake Pad Wear Wire - front brake pad wear warning wire within the braking system. Routed to the front brake pad, the wire completes a circuit tha...

Coolant Flow Control Valve for the cooling circuit of the 5.0L supercharged V8 petrol engine (AJ133). Regulates coolant flow within the engine coo...

O-Ring - seals the upper joint of the thermostat housing. Fitted to 3.0L supercharged V6 and 5.0L V8 petrol engines, it maintains a leak-tight coo...

Coolant Bleed Hose - bleed hose running from the engine to the coolant expansion tank. Fitted to the 2.0L four-cylinder AJ200 petrol engine, it ve...

Accessory Drive Belt - multi-rib belt driving the engine's front-end accessories. Transmits crankshaft rotation to the belt-driven ancillaries wit...

Fuel Sender and Pump is the in-tank fuel delivery module combining the electric fuel pump with the fuel level sender unit, mounted inside the fuel ...

Diesel Exhaust Fluid (AdBlue) for diesel vehicles fitted with a selective catalytic reduction (SCR) exhaust after-treatment system. The fluid is h...

NOx Trap Temperature Sensor within the diesel exhaust aftertreatment system. Mounted in the exhaust stream at the NOx trap, the sensor reports exh...

Exhaust Gas Pressure Sensor for the exhaust and emissions system on 2.0L AJ200P Ingenium petrol and plug-in hybrid applications. The sensor measur...

Head Gasket for the right-hand cylinder bank of the 5.0L V8 AJ133 petrol engine. It seals the cylinder head to the engine block, containing combust...

Cylinder Head Gasket seals the joint between the right-hand cylinder head and the engine block on the 3.0L DOHC supercharged GDI V6 petrol engine. ...

Cylinder Head Gasket for the left-hand cylinder head of the 3.0L DOHC GDI supercharged V6 petrol engine. Seals the machined joint between the left...