Genuine Land Rover Parts

Blanking Plate for the inlet manifold of the 3.5L V8 twin-carburettor petrol engine. The plate closes off an unused port on the manifold to maintai...

Heater Tap Adaptor for the heater control circuit. This zinc-plated mild steel adaptor forms the threaded interface between the heater water valve ...

Differential Pinion Shim - 0.052in. Fitted between the pinion head and its bearing to set pinion depth and preload during differential setup. Shim...

Differential Shim - 0.048in. Fitted during differential assembly to set bearing preload and gear alignment. Shim thickness is selected against mea...

Differential Shim, 0.038in, used during differential build to set bearing preload and gear mesh. It sits against the differential carrier side bea...

Valve Push Rod

Door Check Strap Assembly A check strap that limits how far the side-hinged tailgate opens and holds it at its open position. Fitted to the lower ...

Rear Sill for the left-hand side, in the high cab body configuration. The sill is the structural panel running along the lower edge of the body be...

Female Dovetail for the rear end door latch mechanism. Receives the male dovetail to align and secure the rear door as it closes. Sold individually.

Floor Mat for the second seat row, a ribbed rubber mat protecting the intermediate floor area. Approximate dimensions 1490 x 460 x 3 mm.

Bolt for securing the steering box to the chassis on the Defender. Fits the manual Gemmer recirculating-ball steering box in non-power-assisted st...

Mudguard - Power Take Off for the centre power take-off (PTO) housing. Mounted to shield the centre PTO unit from mud, water and road debris. Prot...

Timing Chain Tensioner Retaining Clip - secures the timing chain tensioner and its spring within the timing cover on the 2.25L four-cylinder petrol...

Mainshaft Thrust Washer for the Series I and Series II gearbox assembly. This 0.135 in (135 thou) washer controls the axial location of 3rd gear o...

Rocker Shaft Stud for the cylinder head valve train, securing a rocker shaft pedestal to the cylinder head. The stud locates and clamps the rocker...

Instrument Finisher for the left-hand side of the facia (dashboard) instrument panel. The finisher frames and trims the instrument area, retaining...

mat BTR1194LOY

Finger Pull for the side door sliding glass window. The outer grip fitted to the sliding glass pane, used to slide the window open and closed.

Carburettor Float Needle is the needle valve that regulates fuel entry into the carburettor float chamber. Actuated by the float, it seats to shut...

Inlet Rocker Bush for the valve gear, forming the bearing surface between the inlet rocker arm and the rocker shaft. The bush locates the inlet ro...

Fuel Pipe - Tap to Tank - a fuel line in the low-pressure diesel supply circuit, running between the fuel tank and the fuel tap. It carries fuel f...

Inlet Manifold forms part of the engine air intake system, distributing the intake charge to the cylinder head inlet ports. Fitted to the 2.5-litr...