90217488 - Gearbox Thrust Washer

- €5,60

€5,60

€5,60 - €5,60

€5,60

Tip: Log in to your account to unlock volume discounts on this item.

OEM: Made by an Original Equipment Manufacturer. This part is made by an original equipment manufacturer or under their license, ensuring compatibility and quality.

Gearbox Thrust Washer

Vehicle Model Land Rover Defender up to 2016
Land Rover Series 1
Land Rover Series 2 and 3

Fitment Notes SERIES 1 — gearbox thrust washer, 4-cylinder (excl. V8)
SERIES 2 & 3 — gearbox thrust washer, 4-cylinder (excl. V8)
DEFENDER — gearbox thrust washer, 4-cylinder (excl. V8)

Alternative Codes

90217488BR 0852

In stock 5 units

4 · Gouda 1 · Drachten

Express delivery available

When will my order arrive?

Order before 15:00 (Mon–Fri): same-day dispatch for in-stock items.
UPS Express (order before 14:00): dispatched today, delivered tomorrow where available.
Netherlands / Belgium / Germany: 2–4 working days.
Other EU countries + UK: 4–8 working days.
Outside EU/UK: delivery times vary — contact us for an estimate.

Items may ship from multiple warehouses at no extra cost.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What does the gearbox thrust washer do?

The gearbox thrust washer controls endfloat, the small amount of shaft movement along its axis, inside the gearbox. It sits against a gear or shaft to set the correct clearance and take axial load. Correct endfloat keeps the gears meshing properly.

Which Land Rovers does this thrust washer fit?

This gearbox thrust washer fits the Land Rover Series 1, Series 2, Series 3 and Defender with the four-cylinder engine, not the V8. It's a gearbox internal part, so confirm your gearbox type and where the washer fits before ordering.

How is the right thrust washer thickness chosen?

Thrust washers are typically supplied in different thicknesses so endfloat can be set within specification during a rebuild. The correct thickness is measured and selected on assembly. Check your gearbox manual's endfloat figures, as the wrong thickness affects gear wear.

Is fitting a gearbox thrust washer a specialist job?

Fitting a gearbox thrust washer is typically a specialist job, because the gearbox must be removed and stripped to reach it. It's usually done during a rebuild while endfloat is measured and set. Workshop tools and gearbox experience are normally needed.