Products

Spring bonnet pull cable return

Fuel Connector Assembly - 2-Hose in the fuel delivery and pressure-regulation circuit. The connector block forms the union for the fuel lines at th...

Fuel block connector assembly (with hose) TD5

Rear Step Assembly - the production-fit folding step mounted at the rear of the vehicle, below the rear door. The step provides footing for access...

Locking Plate - the lower tailboard locking plate, mounted to the rear body. Fitted at the lower hinged tailboard, the plate provides the fixed en...

Nut Plate for the side door latch striker. It provides the captive threaded mounting for the striker, holding the fixing nuts in alignment on the ...

Tailgate Cable Support Bracket for the lower tailgate assembly. The bracket forms the anchor point for the tailgate support cable, which carries th...

Lower Tailboard Bracket is the right-hand bracket for the bottom-hinged rear tailboard, part of the tailboard mounting assembly. It secures the lo...

Lower Tailboard Bracket is the left-hand bracket for the bottom-hinged rear tailboard, part of the tailboard mounting assembly. It secures the low...

Body Strap - 2 Hole is a foam mounting spacer used in the front windscreen hinge assembly on the Defender. This two-hole component sits between th...

Rear Hinge Bracket for the tailgate hinge assembly. The bracket mounts to the rear of the chassis frame and carries the tailgate hinge, locating t...

Bonnet Release Adjusting Plate for the bonnet release mechanism. This plate sets and retains the position of the bonnet release cable at the latch...

Door Hinge Nut Plate - a threaded anchor plate for the rear side door hinge. The plate sits behind the body panel at the door hinge mounting and p...

Intercooler TD5 Puma

Brake Disc - Solid - Front is the front brake disc, mounting to the wheel hub and providing the friction surface the brake pads clamp against durin...

Rear brake shield RH

Brake Disc Splash Shield - Rear - RH - Galv is the right-hand rear brake disc splash shield, the backing plate mounted behind the disc on the rear ...

Rear brake shield LH

Brake Disc Splash Shield - Rear - LH - Galv is the left-hand rear brake disc splash shield, the backing plate mounted behind the disc on the rear a...

Fuel Leak Off O-Ring seals the leak-off (spill return) connection at a diesel fuel injector. It sits in the injector leak-off circuit that collect...

Capping assembly body side Station wagon 110"" RH, one piece, black

Rear Body Capping for the Defender rear body, in galvanised steel. It caps and protects the top edge of the rear body panel and is galvanised for ...

Rear Body Capping for the Defender rear body. It caps and protects the top edge of the rear body panel.

Finisher

EGR Cooler for the exhaust gas recirculation circuit of the 2.4L TDCi Puma diesel engine. The cooler lowers the temperature of recirculated exhaus...

Mass Air Flow (MAF) Sensor mounted in the air intake tract, downstream of the air cleaner. It measures the mass of air drawn into the engine and s...

Door Check Arm Pivot Bracket for the left-hand front door. This bracket anchors the door check arm to the body pillar and forms the pivot point fo...

Door Check Arm Pivot Bracket for the right-hand front door. This bracket anchors the door check arm to the body pillar and forms the pivot point f...

Air Vent Louvre for the dashboard fascia, forming part of the cabin ventilation outlet. This louvre mounts in the dash face and directs air from t...

Exhaust Gas Temperature Sensor measures the temperature of the exhaust stream within the diesel exhaust and emissions system. It reports to the en...

Knock Sensor is part of the engine management system on the V8 petrol engine. Mounted to the cylinder block, it detects combustion knock (detonati...

ABS Sensor - Front for Defenders equipped with automatic transmission. This wheel speed sensor mounts at the front axle hub and continuously monit...

Door Glass Channel for the front door, upper section. This channel runs along the top of the front door frame and guides and seals the window glas...

Starter Motor Puma Replacement - Defender

Fitment All TD5 diesel models up to (VIN) 6A999999 All TD5 diesel models All V8 EFi petrol models 2.5L 6 Cyl BMW Diesel /4.0L and 4.6L EFI V8 P...

Crown Wheel and Pinion Set - the final-drive gear pair inside the axle differential. The pinion takes drive from the propeller shaft and meshes wi...

Crown Wheel and Pinion is the final-drive gear set inside the differential, comprising the ring (crown) gear and its matched drive pinion. The pin...

Seal rear side door RH GENUINE LR

Seal rear side door LH GENUINE LR

Door Sill Seal – Front is the lower weatherstrip fitted along the bottom edge of the front door aperture. It forms a weather barrier at the base o...

ABS Sensor Bush that locates and retains the ABS wheel speed sensor in its mounting. It suits both the front and rear sensor positions.

Front Cylinder Cover encloses the front of the cylinder block on the 2.2L turbo-diesel (Puma) engine, sealing the front timing drive area. It carr...

Oil Filter Adaptor forms the mounting interface for the spin-on oil filter within the engine oil filter and cooler assembly. Bolted to the cylinde...

Injector Bolt for the 2.2L Td4 (Puma) diesel fuel injection system. The bolt retains a fuel injector in its bore in the cylinder head, clamping th...

Exhaust Gas Temperature Sensor - post-catalyst temperature sensor in the exhaust after-treatment system, mounted downstream of the catalytic conver...