Products

Cylinder Head for the 300 TDi 2.5L four-cylinder turbo diesel engine, supplied as a bare casting without valves. The head bolts to the top face of...

Complete Cylinder Head for the 300 TDi 2.5L diesel engine, supplied fully assembled and ready to fit. The head is delivered built up with the valv...

Cylinder Head Bolt for the 2.0L MPi T-series 4-cylinder petrol engine. The bolt clamps the cylinder head to the cylinder block, holding the head g...

Portable Jump Starter and Air Compressor - a handheld 12V power pack combining a battery jump starter, power bank, tyre inflator and LED work light...

Crankshaft Spigot Bush is the clutch pilot bush that presses into the rear face of the crankshaft, between the engine and the clutch. It supports ...

Exhaust Valve for the Rover V8 EFI petrol engine, fitted in the cylinder head valvetrain. The valve seals the exhaust port during the combustion c...

Valve Guide for the cylinder head valve train of the Rover V8 petrol engine. The guide is an interference fit in the cylinder head and locates the...

tappet hydraulic Freel. repl.

Crankshaft Pulley for the 300 TDi 2.5L 4-cylinder turbo diesel, mounted on the nose of the crankshaft at the front of the engine. The pulley trans...

Timing Belt Tensioner maintains correct tension on the timing belt of the 300 TDi 2.5L turbo diesel. The sprung tensioner pulley bears against the...

Valve Stem Cap is a hardened cap that sits over the tip of the valve stem in the cylinder head valve train. It forms the wear interface between th...

Valve Stem Seal for the cylinder head of the 2.0L four-cylinder T-Series MPi petrol engine. The seal fits over the valve stem at the top of the va...

Inlet Manifold Gasket sealing the upper inlet manifold section to the lower inlet manifold section on the 2.0L 4-cylinder MPi T Series petrol engin...

Breather hose rocker cover

Crankcase Breather Hose forms part of the closed crankcase ventilation circuit, connecting the rocker cover breather outlet to the intake manifold ...

Breather Hose for the 300 TDi crankcase ventilation system. The hose carries crankcase breather (blow-by) gases from the engine breather outlet ba...

Oil Separator Drain Hose for the 300 Tdi 2.5L 4-cylinder turbo diesel engine, part of the crankcase ventilation system. It returns the oil collect...

Breather O-Ring for the 2.5L diesel engine (NA Diesel, 200 TDi and 300 TDi), used in the crankcase ventilation system. It seals the cyclone breath...

Blade Fuse rated at 10 A, colour-coded red to match its rating. This standard automotive blade fuse plugs into the vehicle fuse box and protects it...

Brake Light Switch operates the stop lamps within the braking system's electrical circuit. Mounted at the brake pedal, the switch closes when the ...

Front door window regulator forming part of the door glass operating assembly, responsible for controlled raising and lowering of the electric wind...

Front door window regulator assembly for left-hand front door applications within the door glass operating mechanism. This component forms part o...

Clutch Kit is a matched three-piece clutch assembly for the 3.5L V8 petrol engine with manual transmission. The kit renews the complete clutch as ...

Stud M8 x 25

Wheel Wrench a 27mm wheel brace for loosening and tightening wheel nuts. The 27mm socket end matches the wheel nuts fitted to the applicable vehic...

Wheel Wrench a 27mm wheel brace for loosening and tightening wheel nuts. The 27mm socket end matches the wheel nuts fitted to the applicable vehic...

Bumper Moulding - Rear is the moulded end cap that closes off the outer end of the rear bumper, forming the finished corner profile and taking the ...

Bumper Moulding - Front is the moulded end cap that closes off the outer end of the front bumper, forming the finished corner profile and taking th...

Brake servo assembly for the hydraulic braking system within the Master Cylinder & Servo - Less Anti-Lock Braking System assembly group. This...

Spring bonnet pull cable return

Brake Disc - Solid - Front is the front brake disc, mounting to the wheel hub and providing the friction surface the brake pads clamp against durin...

Rear brake shield RH

Rear brake shield LH

Knock Sensor is part of the engine management system on the V8 petrol engine. Mounted to the cylinder block, it detects combustion knock (detonati...

Front Anti-Roll Bar in the front suspension assembly. It links the left- and right-hand suspension sides to resist body roll during cornering, imp...

Anti-Roll Bar is the rear stabiliser bar within the suspension system, mounted transversely across the rear axle. Connected to the suspension thro...

Rear Upper Shock Absorber Bracket, the upper mounting bracket for the rear damper within the rear suspension. It forms the fixed upper anchorage b...

Fulcrum Bracket for the rear suspension A-frame assembly. The bracket provides the chassis mounting point for the A-frame ball joint, which locate...

Propshaft Bolt - a fastener that secures the propshaft universal-joint flange to the differential drive flange within the driveline. It clamps the...

Lower Arm Link – Rear is a rear suspension locating link connecting the rear axle to the chassis on coil-sprung suspension. It locates the axle fo...

Swivel Pin Housing Oil Seal - 9mm seal fitted to the front axle swivel housing. It seals the point where the drive shaft enters the swivel housing...

Fuse rated at 15A for the vehicle electrical system. Fitted in the fusebox to protect a circuit rated at 15 amps, the fuse breaks the connection w...

Brake Caliper Carrier Bolt secures the brake caliper carrier (mounting bracket) to the axle, providing the clamping force that holds the caliper as...

Handbrake Shoe Set for the transmission handbrake. Part of the transfer-box-mounted drum parking brake. The shoes expand against the inside of the...

Shock absorber bracket LH

Shock absorber bracket RH

Brake Disc, front, vented. Part of the front braking system. The disc mounts to the front wheel hub and rotates with the wheel; the brake caliper ...

Brake Disc - a vented front brake disc for the front axle braking system. The disc rotates with the front wheel hub and is clamped by the caliper ...