Range Rover L322 Parts

Cylinder Head Gasket for the 4.4L V8 diesel engine, right-hand cylinder head. It seals the joint between the cylinder head and the engine block, co...

Manifold Absolute Pressure (MAP) Sensor - measures the pressure inside the intake manifold and supplies an engine-load signal to the engine control...

Crankshaft Seal & Retainer – Rear is the rear main oil seal together with its carrier plate, mounted to the rear face of the cylinder block on ...

Oil Pump for the engine lubrication system. It draws oil from the sump and pressurises it through the lubrication circuit to the engine's bearings ...

Oil Cooler Assembly for the 5.0-litre supercharged V8 petrol engine (AJ133). It forms part of the engine lubrication circuit, transferring heat fro...

Oil Seal for the ZF transfer case. Seals a rotating shaft on the transfer case to retain lubricant and exclude contaminants.

Drain Plug Washer for the transfer box drain and level plugs. The washer seals the plug against the transfer box casing and is replaced each time ...

Cylinder Block Core Plug Seal sealing a core plug aperture in the cylinder block. It seals a casting core plug opening in the block, preventing co...

Oil Drain Plug for the ZF transfer box housing. The plug closes the drain and fill port in the transfer box casing, and is removed to drain and re...

Wheel Nut Set - Satin Black - set of twenty wheel nuts in a satin black finish, sufficient for four five-stud road wheels. Each nut clamps the roa...

Sensor - High Low Position - Tripminder

Electronic Pressure Control Solenoid for the transfer case control circuit. The solenoid is actuated electrically by the vehicle's control module ...

Brake Pad Front Green

Fuel Pressure Regulator for the right-hand cylinder bank of the 4.4L DOHC V8 turbo diesel (TDV8) engine, supplied with its valve. Regulates pressu...

Sensor exhaust gas oxygen

Oil Cooler Assembly - the oil-to-coolant heat exchanger of the engine's Oil Cooler and Filter assembly. Engine coolant is passed through the coole...

CANNY is an advanced CAN interface developed by Lazer Lamps that enables the seamless installation of auxiliary lights on modern vehicles equipped ...

Sensor - Exhaust Gas - Temperature

Secondary Drive Belt Idler guides and maintains tension on the secondary (supercharger) drive belt within the front-end accessory drive. The idler...

Front timing cover - the lower centre cover that closes the front face of the cylinder block over the timing chain drive. It carries the crankshaf...

Oil Cooler Assembly - the oil-to-coolant heat exchanger of the engine's Oil Cooler and Filter assembly. Engine coolant is passed through the coole...

Exhaust Gas Temperature Sensor for the diesel particulate filter (DPF) system. Monitors exhaust gas temperature in the after-treatment section and...

Manifold Absolute Pressure (MAP) Sensor - an engine-management sensor mounted on the inlet manifold of the 4.4L DOHC DITC V8 diesel engine. The se...

Timing Chain Tensioner for the timing chain drive of the 5.0L V8 (AJ133) and 3.0L supercharged V6 petrol engines. It bears against the timing chain...

Tyre Pressure Sensor (TPMS) for the direct tyre pressure monitoring system. Fitted at the wheel valve inside the tyre, it measures tyre pressure an...

Drive Belt Tensioner for the secondary (supercharger) belt drive fitted to the supercharged petrol V6 and V8 engines. It uses a spring-loaded pivot...

Fuel Injector for the 5.0L V8 AJ133 petrol engine. It meters and atomises fuel for combustion under the control of the engine management system. O...

Oil Pump, the pump at the heart of the engine lubrication system. Driven by the engine, it draws oil from the sump and delivers it under pressure ...

Oil Filter Housing Cover is the cover for the cartridge-type oil filter assembly on 3.0 GDI petrol and 5.0 AJ-V8 engines. This cover retains the r...

Water Pump for the 4.4L DOHC V8 turbo-diesel (TDV8) engine. It circulates coolant through the engine block, cylinder heads and radiator to maintain...

Automatic Transmission Fluid Change Kit for the ZF 8HP eight-speed automatic gearbox - transmission oil pan and fluid service. The eight-speed gea...

Variable Valve Timing Solenoid - oil control solenoid for the variable valve timing system. The solenoid regulates engine oil flow to the camshaft...

Auxiliary coolant pump serving the charge-air cooling circuit on supercharged petrol engines. The pump is electrically driven and runs independent...

D3S xenon headlamp bulb, supplied with its igniter, for headlamp units originally built as bi-xenon or adaptive xenon assemblies. D3S is a mercury...

Cylinder Head Cover (Camshaft Cover) for the 5.0L V8 AJ133 petrol engine, naturally aspirated and supercharged applications. The cover bolts to th...

Tensioner - Drive Belt

Fan Bracket for the secondary drive belt system, supplied complete with idler pulley and belt tensioner. The bracket mounts to the front of the en...

8HP Gearbox Service Kit supplies the components for a complete fluid change on the ZF 8HP70 eight-speed automatic transmission. On this gearbox the...

Alternator Bracket mounts and locates the alternator on the engine, positioning it within the accessory drive belt run. Designed for the 4.4L DOHC...

Throttle Body for the air intake system of the 4.4L V8 diesel engine. The electronically actuated throttle valve regulates intake airflow into the...