Products

Front Brake Disc, internally vented, for the front axle service brake assembly. The disc provides the friction surface for the front brake pads an...

Front Brake Pad Wear Sensor for the front axle brake assembly, forming part of the brake pad wear warning circuit. The sensor is a wire loop carri...

Front Brake Pad Wear Sensor for the front axle brake assembly, part of the brake pad wear warning circuit. The sensor consists of a wire loop seat...

Coolant Temperature Sensor mounted in the cylinder head coolant gallery, part of the engine cooling and engine management system. The sensor is a ...

Cabin Pollen Filter, 272x195x43mm - the filter element in the HVAC intake housing, installed upstream of the blower motor and evaporator. All air ...

Cabin Pollen Filter, 272x195x43mm - the filter element in the HVAC intake housing, installed upstream of the blower motor and evaporator. All air ...

Glow Plug - the pre-heat element for one cylinder of the 2.0L four-cylinder AJ200 / AJ20D4 diesel engine, threaded into the cylinder head so its ti...

Glow Plug - the pre-heat element for one cylinder of the 2.0L four-cylinder AJ200 / AJ20D4 diesel engine, threaded into the cylinder head so its ti...

Exhaust Gas Pressure Sensor for the diesel exhaust aftertreatment system. The sensor is connected by take-off pipes to the exhaust upstream and do...

Front Brake Pad Set for the front disc brake and caliper assembly, supplied as a front axle set. The pads sit in the front caliper carriers and ar...

Front Brake Pad Set for the front disc brake and caliper assembly, supplied as a front axle set. The pads sit in the front caliper carriers and ar...

Front Crankshaft Oil Seal for the Ingenium engine family, sealing the crankshaft nose where it passes through the front cover. The seal runs on th...

NOx Trap Temperature Sensor from the exhaust aftertreatment system of the 2.0L I4 AJ200 Ingenium diesel engine. The sensor reports exhaust gas tem...

Front suspension strut insulator is installed within the front suspension strut assembly, positioned between the shock absorber upper mounting poin...

Brake Pad Set - Rear

Brake Pad Set - Rear

Primary Timing Chain Tensioner from the timing drive assembly at the front of the 2.0L four-cylinder AJ200 / AJ20P4 engine. The tensioner bears ag...

Output Shaft Oil Seal from the external components of the ZF 9HP48 / 9HP50 nine-speed automatic transmission. The seal fits around the gearbox out...

Drive Chain Idler - timing gear idler sprocket for the 2.0L four-cylinder Ingenium engine family (AJ200 / AJ20 series, petrol and diesel). The idl...

Front Axle Drive Shaft - Joint and Stub Shaft, part of the front axle drive assembly. It transmits drive from the front differential to the front ...

Drive Shaft Boot Kit - Outer Constant Velocity Joint - Front, part of the front axle drive shaft assembly. The boot seals the outer constant veloc...

Timing Chain Guide - LH Primary - a fixed guide in the timing drive assembly of the 2.0L four-cylinder Ingenium petrol engine (AJ200 / AJ20P4), inc...

Fuel Injector for the 2.0L I4 Ingenium (AJ200) diesel engine, part of the high-pressure common rail fuel injection system. The injector is clamped...

Tie Rod from the steering linkage, running between the steering rack and the steering knuckle. It transmits rack travel to the hub carrier to stee...

Bolt for the camshaft timing gear, part of the Ingenium engine timing drive. It retains the timing sprocket to the camshaft, transferring drive fr...

Rear Wheel Hub Bearing from the rear hub and bearing assembly, supplied as a sealed unit. The hub bolts to the rear suspension knuckle and carries...

Relay is a 4-pin electromechanical switching relay used within the vehicle's electrical system. A low-current control signal energises the 12V coi...

Ceramic Glow Plug - cold-start heating element from the diesel pre-heat system, threaded into the cylinder head with the tip projecting into the co...

Front Brake Hose - Left-Hand - the flexible hydraulic hose on the left-hand front corner, connecting the rigid brake pipe on the body to the front ...

Rear Shock Absorber - hydraulic damper for the rear suspension, fitted between the body mounting point and the rear suspension arm. The damper con...

Drive Belt for the belt-driven starter generator (BSG) drive at the front of the engine. The belt transmits torque between the crankshaft pulley a...

Oil Pressure Switch from the engine lubrication system. The switch threads into an oil gallery and monitors lubricating oil pressure, signalling t...

Timing Cover Blanking Plug - threaded plug that closes an aperture in the front timing cover of the 2.0L Ingenium petrol engine (AJ200 / AJ20P4, al...

Lambda Sensor - exhaust gas oxygen sensor in the exhaust after-treatment system of the 2.0L Ingenium diesel engine (AJ200D / AJ20D4), working with ...

Ball Stud - Tailgate Strut - the ball pivot that a tailgate (luggage compartment door) gas strut socket clips onto. It threads into the body apert...

DEF Injector Refit Kit

IDLER-DRIVE BELT 80MM 2.0D 2.0L I4 L462/L494/L538/L550/L551/L560/L663

Engine Mounting Bolt, M14 x 65mm, used in the engine mounting assembly. The bolt secures the engine mounting to its bracket. It carries the static...

O-Ring for the high-pressure diesel fuel injection pump. The ring seals the joint between the pump body and its mounting face on the engine, preve...

Timing Chain - Secondary, Upper is part of the camshaft drive of the 2.0L Ingenium four-cylinder petrol engine (AJ200 / AJ20P4), including plug-in ...