Allmakes4x4 Parts

Nut and Washer Assembly is an M6 hexagonal nut supplied together with its washer as a single assembly. The washer spreads the clamping load across...

Blanking Plug - timing chain cover, supplied with its O-ring. Seals a machined service aperture in the timing chain cover of the Ingenium engine f...

Water Connection for the turbocharger coolant feed, lower position, in the turbocharger lubrication and cooling circuit of the 3.0L AJ20P6 Ingenium...

Crankcase Breather Cover - part of the crankcase ventilation assembly on the 3.0L Ingenium AJ20P6 six-cylinder petrol engine. The cover closes the...

Crankcase cover gasket for the crankcase ventilation (emission control) cover on the 3.0L Ingenium six-cylinder petrol engine - AJ20P6 / AJ22P6, in...

Spark Plug - ignition spark plug for Ingenium petrol engines (AJ20 / AJ22 series, including PHEV applications). The plug screws into the cylinder ...

Blind Rivet Pin is a plastic blind-rivet fastener, 9.4 mm head diameter by 13 mm long. It secures trim panels, covers and liners by expanding to g...

Tyre Pressure Sensor - wheel-mounted sensor forming part of the Tyre Pressure Monitoring System (TPMS). The sensor is fitted at the valve position...

Screw - threaded fastener used in body and chassis assembly.

O-Ring

Brake pad wear sensor for the rear brakes, forming part of the brake pad wear warning circuit. The sensor is a wire loop carried in a moulded body...

Brake pad wear sensor for the rear brakes, forming part of the brake pad wear warning circuit. The sensor is a wire loop carried in a moulded body...

Front Brake Pad Wear Sensor, part of the front brake pad and caliper assembly. The sensor is a sacrificial wire loop held in a moulded carrier tha...

Front Brake Pad Wear Sensor, part of the front brake pad and caliper assembly. The sensor is a sacrificial wire loop held in a moulded carrier tha...

Air Filter is the engine intake air filter element, carried in the air cleaner housing upstream of the turbocharger inlet. It traps dust, grit and...

Ball Stud - Tailgate Strut - the ball pivot that a tailgate (luggage compartment door) gas strut socket clips onto. It threads into the body apert...

Ceramic Glow Plug - cold-start heating element from the diesel pre-heat system, threaded into the cylinder head with the tip projecting into the co...

Mini Relay with four blade terminals, rated at 70 amp, grey housing. A four-terminal mini relay switches a single normally-open high-current circu...

Screw - a fastener used to secure exterior body panels and trim, including body mouldings, front and rear bumper assemblies, radiator grille panels...

Fuel Injector Sealing Washer for the fuel injection system. Seals the fuel injector against the cylinder head, maintaining the combustion seal and...

Clip is a fastening used within the body moulding assembly, retaining exterior trim and moulding panels against the bodywork.

O-Ring sealing a turbocharger oil and coolant connection within the turbocharger lubrication and cooling circuit. It seals the union at the turboc...

Diesel Exhaust Fluid (AdBlue) is a consumable fluid for the Selective Catalytic Reduction (SCR) exhaust aftertreatment system on diesel engines. I...

Brake Fluid - DOT 4 low-viscosity hydraulic brake fluid, supplied in a 1 litre container. It transmits pedal pressure through the hydraulic brakin...

Air Suspension Connector joins the valve block to a high-pressure air line within the air suspension pneumatic circuit. The fitting forms a sealed...

Bolt is a threaded fastener used within the chassis and suspension assemblies. It secures mounting points across suspension, stabilizer bar and re...

M16 Nut for the front suspension arm. Secures a front suspension arm mounting fastener, holding the joint under suspension loads.

Brake Disc Retaining Screw that locates the brake disc against the wheel hub flange, holding the disc square and in position while the caliper and ...

Fuel Pump O-Ring Seal, 31mm x 2mm - the sealing ring at the fuel pump / fuel injection pump joint. This O-ring is the only seal at that joint, so ...

Set Screw, a hexagon-head metric fastener, M10 x 25mm. In Land Rover terminology a set screw is a bolt threaded along its full length rather than ...

Kinetic Recovery Rope - vehicle recovery accessory for extracting a bogged or stuck vehicle. Unlike a static strap, a kinetic rope stretches under...