Allmakes4x4 Parts

Mudflaps - Front

Front Mud Flaps - moulded flaps fitted at the trailing edge of the front wheel arches, at the lower body. Each flap hangs behind the front tyre to...

screw M5 x 12

Nut and Washer Assembly is an M6 hexagonal nut supplied together with its washer as a single assembly. The washer spreads the clamping load across...

Nut - an M8 x 1.25 captive U-spring nut used to mount the air suspension compressor. The spring-steel body clips over the chassis bracket to provi...

Anti-Roll Bar Link - Front, the connecting link between the front anti-roll bar end and the suspension strut in the front suspension assembly. The...

Window Control Switch for the driver's door, in the double configuration. The switch is mounted in the driver's door armrest and operates the elec...

Accessory Drive Belt for the front end accessory drive of the 2.0L Ingenium four-cylinder engine (AJ200 / AJ20P4, petrol and diesel applications). ...

Blanking Plug - timing chain cover, supplied with its O-ring. Seals a machined service aperture in the timing chain cover of the Ingenium engine f...

Wheel hub bearing for the front and rear knuckle and hub assemblies. The bearing carries vehicle load between the hub and the knuckle and allows t...

Spark Plug - ignition spark plug for Ingenium petrol engines (AJ20 / AJ22 series, including PHEV applications). The plug screws into the cylinder ...

Blind Rivet Pin is a plastic blind-rivet fastener, 9.4 mm head diameter by 13 mm long. It secures trim panels, covers and liners by expanding to g...

Suspension Arm - Front - LH is a front control arm fitted to the left-hand side of the front suspension assembly. It locates the front wheel hub c...

Suspension Arm - Front - RH is a front control arm fitted to the right-hand side of the front suspension assembly. It locates the front wheel hub ...

Tyre Pressure Sensor - wheel-mounted sensor forming part of the Tyre Pressure Monitoring System (TPMS). The sensor is fitted at the valve position...

Screw - threaded fastener used in body and chassis assembly.

Magnetic Oil Drain Plug - M14 x 21 sump drain plug in the engine lubrication system. The plug seals the drain aperture in the oil sump and is remo...

Tailgate Latch is the closure latch of the tailgate / luggage compartment lock controls. It engages the body-mounted striker to hold the tailgate ...

Engine Mounting Bolt, M14 x 65mm, used in the engine mounting assembly. The bolt secures the engine mounting to its bracket. It carries the static...

Ball Stud - Tailgate Strut - the ball pivot that a tailgate (luggage compartment door) gas strut socket clips onto. It threads into the body apert...

Timing Cover Blanking Plug - threaded plug that closes an aperture in the front timing cover of the 2.0L Ingenium petrol engine (AJ200 / AJ20P4, al...

Ceramic Glow Plug - cold-start heating element from the diesel pre-heat system, threaded into the cylinder head with the tip projecting into the co...

Mini Relay with four blade terminals, rated at 70 amp, grey housing. A four-terminal mini relay switches a single normally-open high-current circu...

Rear Wheel Hub Bearing from the rear hub and bearing assembly, supplied as a sealed unit. The hub bolts to the rear suspension knuckle and carries...

Transmission Sleeve Kit

Output Shaft Oil Seal from the external components of the ZF 9HP48 / 9HP50 nine-speed automatic transmission. The seal fits around the gearbox out...

NOx Trap Temperature Sensor from the exhaust aftertreatment system of the 2.0L I4 AJ200 Ingenium diesel engine. The sensor reports exhaust gas tem...

Cabin Pollen Filter, 272x195x43mm - the filter element in the HVAC intake housing, installed upstream of the blower motor and evaporator. All air ...

Front Brake Pad Wear Sensor for the front axle brake assembly, forming part of the brake pad wear warning circuit. The sensor is a wire loop carri...

Front Brake Pad Wear Sensor for the front axle brake assembly, forming part of the brake pad wear warning circuit. The sensor is a wire loop carri...

Front Wiper Blade - Passenger's Side is the passenger's side blade of the front windscreen wiper system in left-hand drive configuration. It is th...

Front Wiper Blade - Driver's Side is the driver's side blade of the front windscreen wiper system in left-hand drive configuration. It is the long...

Engine Mount Insulator - Upper is the bonded rubber-to-metal isolator fitted in the upper engine mounting position of the transverse Ingenium power...

Brake Caliper is the rear brake caliper within the rear disc brake assembly. It houses the hydraulic piston and carries the brake pads; under brak...

Brake Caliper is the rear brake caliper within the rear disc brake assembly. It houses the hydraulic piston and carries the brake pads; under brak...

Air Conditioning Compressor - Kit

Screw - a fastener used to secure exterior body panels and trim, including body mouldings, front and rear bumper assemblies, radiator grille panels...

Sealing Ring - 34.2 x 3.0mm O-ring that seals a joint in the thermostat housing and EGR cooling circuit. Fitted to the 2.0L four-cylinder AJ200/AJ...

Auxiliary Coolant Pump - an electrically driven pump in the engine cooling system that circulates coolant independently of the belt-driven main wat...

Fuel Injector Sealing Washer for the fuel injection system. Seals the fuel injector against the cylinder head, maintaining the combustion seal and...

Brake Pad Wear Wire is the rear brake pad wear warning sensor, fitted to the rear brake pads within the rear disc and caliper assembly. The wire c...