Products

Fuel Injector Sealing Washer for the fuel injection system. Seals the fuel injector against the cylinder head, maintaining the combustion seal and...

Front Crankshaft Oil Seal for the AJ200 2.0L four-cylinder petrol and diesel engine. It seals the front of the crankshaft where it passes through t...

Diverter Solenoid Valve for the turbocharger compressed-air recirculation (shut-off) circuit. On the 3.0L V6 diesel, it controls compressed-air re...

Timing Chain Tensioner, part of the timing chain drive within the timing cover. It applies controlled load to the timing chain guide to keep the ch...

Air Suspension Compressor - the compressor unit that supplies pressurised air to the four-corner air suspension system. It draws in and compresses...

Water Pump is the engine-driven mechanical pump that circulates coolant through the cylinder block, cylinder heads and radiator to maintain engine ...

EGR Valve and Throttle Body Assembly from the engine's exhaust gas recirculation and intake system. The EGR valve meters recirculated exhaust gas b...

Screw - a fastener used to secure exterior body panels and trim, including body mouldings, front and rear bumper assemblies, radiator grille panels...

Fuel Pressure Sensor for the high-pressure fuel injection circuit on petrol engines. It measures fuel rail pressure and temperature and reports to ...

EGR Valve Assembly for the high-pressure exhaust gas recirculation circuit on the 2.0-litre AJ200 diesel engine. The assembly combines the EGR valv...

Pump - Oil & Vacuum

Brake Pad Set - Front for the front axle disc brakes. A complete set of front brake pads for one axle. The pads act against the front brake discs ...

Brake Pad Set - Front with a ceramic friction compound, for the front axle disc brakes. A complete set of front brake pads for one axle, using a c...

Track Rod End for the steering linkage. The track rod end is the ball-jointed connection at the outer end of the steering tie rod, linking the ste...

Track Rod End for the steering linkage. The track rod end is the ball-jointed connection at the outer end of the steering tie rod, linking the ste...

Turbocharger Gasket for the 2.0L AJ200D Ingenium four-cylinder diesel, sealing the turbocharger mounting joint against exhaust gas leakage. The ga...

Air Conditioning Compressor for the 3.0L V6 diesel - the driven unit at the head of the air conditioning refrigerant circuit. Mounted on the engin...

Exhaust Manifold Stud secures the exhaust manifold flange to the cylinder head within the exhaust assembly. This is a double-ended stud, threaded ...

Brake Caliper - rear right-hand unit, 17-inch brake size. The caliper houses the hydraulic pistons that clamp the brake pads against the rear disc ...

Brake Caliper - rear left-hand unit, 17-inch brake size. The caliper houses the hydraulic pistons that clamp the brake pads against the rear disc u...

Crankshaft Pulley with integral torsional damper, part of the front-of-engine auxiliary drive on the 2.0L I4 AJ200 Ingenium petrol and diesel engin...

Suspension Arm - front lower control arm (wishbone) forming part of the front suspension, locating the wheel hub carrier to the subframe and contro...

Suspension Arm - front lower control arm (wishbone) forming part of the front suspension, locating the wheel hub carrier to the subframe and contro...

Drive Belt Tensioner for the accessory drive belt system of the 2.0L I4 Ingenium (AJ200 / AJ20) petrol and diesel engine. This is a double belt te...

Air Conditioning Condenser is the front-mounted heat exchanger of the air conditioning refrigerant circuit, carried in the cooling pack ahead of th...

Coolant Temperature Sensor mounted in the cylinder head coolant gallery, part of the engine cooling and engine management system. The sensor is a ...

Glow Plug - the pre-heat element for one cylinder of the 2.0L four-cylinder AJ200 / AJ20D4 diesel engine, threaded into the cylinder head so its ti...

Glow Plug - the pre-heat element for one cylinder of the 2.0L four-cylinder AJ200 / AJ20D4 diesel engine, threaded into the cylinder head so its ti...

Primary Fuel Filter - diesel fuel supply circuit, mounted in-line in the fuel lines between the tank and the engine. As the first filtration stage...

Turbocharger

Front Brake Disc for the front axle braking assembly. The disc mounts to the front wheel hub and rotates with the road wheel, presenting the frict...

Rear Brake Disc for the rear axle braking assembly. The disc mounts to the rear wheel hub and rotates with the road wheel, providing the friction ...

Front Upper Suspension Arm - Left Hand - upper control arm in the front double-wishbone suspension assembly. It locates the top of the front wheel...

Front Upper Suspension Arm - Left Hand - upper control arm in the front double-wishbone suspension assembly. It locates the top of the front wheel...

Front Upper Suspension Arm - Right Hand - upper control arm in the front double-wishbone suspension assembly. It locates the top of the front whee...

Front Upper Suspension Arm - Right Hand - upper control arm in the front double-wishbone suspension assembly. It locates the top of the front whee...

Front Crankshaft Oil Seal for the Ingenium engine family, sealing the crankshaft nose where it passes through the front cover. The seal runs on th...

Pump - Water Hepu

Drive Belt - V-belt in the front-end accessory drive of the 3.0L Ingenium six-cylinder petrol engine, driving the belt-integrated starter generator...

Exhaust Manifold Bolt for the 3.0L V6 diesel engine, securing the exhaust manifold to the cylinder head. The bolt works in a high-temperature, hig...

Bearing - Wheel Hub